NUT AND SADDLE SANDER CANADA+USA
PLEASE READ
*Shipping to USA by UPS standard is $12 (customers will be charged $17 at the checkout and then refunded $5 when a shipping label is printed). Please contact us if you have any questions about import.
*Shipping to Canada by UPS or Canada Post Expedited. Prices for shipping in Canada fluctuate greatly depending on locations, and it is hard to predict. A flat rate of $17 will be charged at check out.(except $22 for BC) Any savings will then be refunded after a shipping label is printed. Customers will only be charged the exact shipping cost as per address. Please contact us if you have any questions.
When purchasing multiple items, the shipping cost shown at checkout will only be for the first one. An invoice for the additional combined shipping cost (if any) will be sent to you. Order will be fulfilled after the customer's agreement to pay an additional cost (if any).
Replacing, or adjusting a guitar neck nut or an acoustic guitar saddle is one of the most common jobs done in the guitar repair shop. Every busy luthier should have one in his toolbox.
It is not possible getting your nut bottom sanded square just by holding it with your hand. You do need some tool to hold it in, to get it right for a tight fit that makes for a good tone.
GUITAR NUT AND SADDLE SANDER will help you to do that.
Just pop it in and ride the sander on the strip of sandpaper on a flat surface, until the wheels start turning.
Not only the bottom of your nut or saddle will get perfectly squared and flat, but you will also be able to use adjustment screws placed in one of the corresponding set of holes (on set for the nut, another for a saddle) to dial the exact amount you want to remove.
The markings (8 of them) under the adjusting screws make for a very fine adjustment. Each mark equals about 0.1 mm.
In imperial, one whole turn is 1/32", so 4 marks is 1/64", and so on.